File information: | |
File name: | LG_LB01M_32LV3500-TG_[SM].pdf [preview LG LB01M 32LV3500-TG [SM]] |
Size: | 7336 kB |
Extension: | |
Mfg: | LG |
Model: | LG LB01M 32LV3500-TG [SM] 🔎 |
Original: | LG LB01M 32LV3500-TG [SM] 🔎 |
Descr: | LG Monitor LG_LB01M_32LV3500-TG_[SM].pdf |
Group: | Electronics > Computer equipment > Monitors |
Uploaded: | 02-01-2020 |
User: | Anonymous |
Multipart: | No multipart |
Information about the files in archive: | ||
Decompress result: | OK | |
Extracted files: | 1 | |
File name LG_LB01M_32LV3500-TG_[SM].pdf Internal Use Only North/Latin America http://aic.lgservice.com Europe/Africa http://eic.lgservice.com Asia/Oceania http://biz.lgservice.com LED LCD TV SERVICE MANUAL CHASSIS : LB01M MODEL : 32LV3500/350Y/3530 32LV3500/350Y-TG 32LV3530-TK CAUTION BEFORE SERVICING THE CHASSIS, READ THE SAFETY PRECAUTIONS IN THIS MANUAL. P/NO : MFL67002730 (1110-REV00) Printed in Korea SAFETY PRECAUTIONS IMPORTANT SAFETY NOTICE Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the Schematic Diagram and Exploded View. It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent Shock, Fire, or other Hazards. Do not modify the original design without permission of manufacturer. General Guidance Leakage Current Hot Check (See below Figure) Plug the AC cord directly into the AC outlet. An isolation Transformer should always be used during the servicing of a receiver whose chassis is not isolated from the AC Do not use a line Isolation Transformer during this check. power line. Use a transformer of adequate power rating as this Connect 1.5 K / 10 watt resistor in parallel with a 0.15 uF capacitor protects the technician from accidents resulting in personal injury between a known good earth ground (Water Pipe, Conduit, etc.) from electrical shocks. and the exposed metallic parts. Measure the AC voltage across the resistor using AC voltmeter It will also protect the receiver and it's components from being with 1000 ohms/volt or more sensitivity. damaged by accidental shorts of the circuitry that may be Reverse plug the AC cord into the AC outlet and repeat AC voltage inadvertently introduced during the service operation. measurements for each exposed metallic part. Any voltage measured must not exceed 0.75 volt RMS which is corresponds to If any fuse(or Fusible Resistor) in this TV receiver is blown, replace 0.5 mA. it with the specified. In case any measurement is out of the limits specified, there is |
Date | User | Rating | Comment |